Need help with Invictus cockpit files

[Vampirefox]

hi,

I´m new to basically all of this and just bought the F-16 cockpit plans from Invictud cockpit plans and wanted to check out the stl. files, seeing if i might be able to print some of them before I find someone for the wooden structure itself, only to find out that they aren´t at the right scale.

I opened them in Cura and all pieces looked to be no bigger than a few centimeters. Does anyone else had the same problem and could perhaps provide the right size for them?

[Cassman]

I think the STL is in inches, and your slicer is in mm. Try scaling up by 25.4

[Vampirefox]

thanks, that completely slipped my mind.
I compared it with Moon´s Centre Pedestal and it seems to be around the same
Thank you really