AIC center console

[white-eagle]

You allways need a resistor to connect a led to 5V. But the lightboard has privisions to hold resistor arrays, so you can connect your leds directly.

[Tiger 21]

Ok thanks,

I tested this and it did work, but was just wondering

thank!


Steven

[white-eagle]

Not really part of the AIC project, but since I had nothing to do  I designed a pcb for Mike's ATD.

Not sure yet if I will offer it, depends on the interest. But here are some pictures:

[Nigel]

I am interested. My home-made one works but I never put in backlighting.
Nigel

[Hero]

I would like two of them

[rudolf]

I would be interested also!

[lightning]

Me too

[Taipan]

Probably me too

[Killratio]

Yes, I'm in for one!

[ROCKY]

Yes, I would be interested.

[Kukki]

Hey Arend!
is the size/mesurement of the ATD the real one, so it fits in the real screwholes?

Kukki

[Red Dog]

geez, you guys are like flies on ... ok ok
There comes another fly. I'm in as well should it becoem available

[Tulkas]

Only one good, stabilised 12v power supply (at least 2 Amp's) is needed to power all the boards, except for the light boards.

Sorry to pop up in the middle of the ATD board chat but I have a doubt about AIC center console...

I am about to buy a power supply for my AIC and as always -since electronics are a kind of magic to me- I am terrified to do something wrong and fry some expensive piece of equipment.

White Eagle please, would you bless any of this options in my local store to power de AIC CC board?:

http://www.clasohlson.co.uk/Product/Product.aspx?id=142620418
http://www.clasohlson.co.uk/Product/Product.aspx?id=147461869

Feel free to point out any other device that you think would be better:

http://www.clasohlson.co.uk/product/category.aspx?category=batteries/chargers:voltage+converters/inverters&id=88597222&_path=251882;85177594;88597215;88597222

Thanks a lot.

Tulkas

[white-eagle]

Tulkas, The first two are fine.
The third one is a no-go.

Make sure they are set to 12 volt and the + is the center hole and the - is the outer contact.

That way you are good to go.

[Nigel]

Hi Arend,
Is there a chance this will be made? If it is, please put me on the list as confirmed. I have the ATD screen functioning in my pit and I love it but I really need backlighting. This is awesome Arend and I REALLY hope you make it. I see ten above and I know that Jay will want at least one.
Regards,
Nigel

Not really part of the AIC project, but since I had nothing to do   I designed a pcb for Mike's ATD.

Not sure yet if I will offer it, depends on the interest. But here are some pictures:

Hi Arend,
Is there a chance this will be made? If it is, please put me on the list as confirmed. I have the ATD screen functioning in my pit and I love it but I really need backlighting. This is awesome Arend and I REALLY hope you make it. I see ten above and I know that Jay will want at least one.
Regards,
Nigel