Simulation Software > Falcon BMS

Customizing Default Point of View in BMS

(1/3) > >>

Tulkas:
Now that I have installed a HUD frame I have to slightly move the view and reduce the zoom every time I start a flight. Also when centering TrackIR is slightly too high.

Is there a way to save the viewpoint so it is spot on everytime I start the sim?

Thanks!

Tulkas

jjbravo:
You can set a custom view and use a key command to set it.
Look in the technical manual in section 4.3.1

Atlas:
The BMS viewpoint should be the "correct" one at the design eye.  Could you adjust your position instead?

Tulkas:

--- Quote from: Atlas on April 13, 2024, 11:06:46 AM ---The BMS viewpoint should be the "correct" one at the design eye.  Could you adjust your position instead?

--- End quote ---

Not without rebuilding the complete cockpit  :lol: I'd think is easier to adjust the POV a couple of degrees...

Cannot be clamed that default position is the good one for everybody, the zoom for example is going to depend on the size of your screen/ projection.

Atlas:
Why rebuild the cockpit?  Could you not just raise the seat up and then find a way to fix it in place once at the right height?

Navigation

[0] Message Index

[#] Next page