Hello Sy,
I just cut a full set of the plans and they look great.
I have just a question.
I have Hispapanels Misc panel, Block 50
And I compared it to Viperpanel's Misc
They both look the same.
But the holes in the Misc Support do not match the panel's
If I match the Bottom ones and the square, the top holes sit off by 5 mm down.
I check the cutted piece with the drawing and they match.
Of course I can hollow the Misc Support to fit anything, leaving only space to match the Panel fixing bolts (Might do that anyway)
Just wondering, you have planned the Misc support for what version of Misc Panel ?
Regards,
Pedro "HammerPT" Caldeira